Construction & Home · Area & Materials
Formula verified
Gravel Calculator
Enter the area's length, width and how deep you want the gravel to order the right amount, with room for waste.
Area
ft
ft
in
%
tons/cu yd
On-screen number pad
Tap to type into the highlighted field
Cubic yards needed
2.72
3.80 tons
Cubic feet
73.3
Tons
3.80
Step-by-step proofCheck by hand
This is a planning estimate. Actual gravel needs vary by compaction, base preparation and the specific material's density. Order a small amount extra and confirm the exact density (tons per cubic yard) with your supplier before finalizing a large order.
Ad slot · 970×250 billboard
Ad slot · 300×250
How the gravel quantity is calculated
Length times width times desired depth (converted from inches to feet) gives the raw volume needed, increased by a waste allowance for compaction and uneven ground. That's converted to cubic yards for ordering, then to tons using a density figure — gravel is typically sold and priced by weight, not volume.
The formula
cu ft = L × W × (depth ÷ 12) × (1 + waste%) · cu yd = cu ft ÷ 27 · tons = cu yd × density
Worked example
A 20 ft × 10 ft driveway at 4 inches deep with 10% waste: 20 × 10 × 0.333 × 1.10 = 73.3 cu ft, which is 2.72 cubic yards — about 3.80 tons at a density of 1.4 tons per cubic yard.
Frequently asked questions
How much gravel do I need for a driveway?
Multiply the driveway's length by its width to get the area, multiply by the depth (converted from inches to feet) to get a volume, then convert that volume to cubic yards for ordering — this calculator does all three steps and adds your chosen waste allowance on top.
Why does the calculator show tons as well as cubic yards?
Gravel suppliers often sell and price by weight (tons) rather than volume, since bulk material settles and compacts differently depending on moisture and particle size. This calculator converts the volume to an estimated weight using a typical gravel density of 1.4 tons per cubic yard, which you can adjust if your supplier quotes a different figure for your specific material.
How deep should a gravel driveway or path be?
A common published range for a gravel driveway base is 4 to 6 inches, sometimes built up in a compacted base layer plus a thinner top-dressing layer; a walking path is often shallower, around 2 to 3 inches. Local conditions, soil type and expected vehicle weight all affect the right depth, so check with a local contractor for anything load-bearing.
Sources and method
- Volume-to-weight conversion via standard published bulk-material density figures for crushed stone and gravel (approximately 1.4 tons per cubic yard, varying by material and moisture).